Veterans Day Workout: Getting Back in the Fight with BFR
Workout of the Week · Veterans Day Special · By the RockCuff Team
The short answer: This Veterans Day workout is a short, light-load blood flow restriction (BFR) session built for veterans who want to get back in fighting shape, or stay there, without a heavy bar or a long gym day. With RockCuff cuffs tight on both upper arms and both upper thighs, you do four full-body moves (sit-to-stand, counter push-up, glute bridge and supported one-arm row) using bodyweight or a light dumbbell, in about 22 minutes. Most moves use a 30-15-15-15 rep scheme with about 30 seconds of rest between sets. First session? 15-15-15 is enough, about 15 minutes in all.

Who This Workout Is For
Veterans who want to get back in fighting shape, or stay there, without a heavy bar or a long gym day. It's the kind of training Dave Lucero has relied on for years.
Dave Lucero: Training Through Recovery
Dave Lucero is a retired Chief Warrant Officer and a military veteran of forty years. In a letter he sent RockCuff last spring, then 68, he wrote that the cuffs had been part of his training for six years.
Staying active, he said, matters for muscle mass and bone density. The cuffs had become "a constant part of every workout I perform."
They also helped him keep training through recovery:
After knee surgeries: he worked out with the cuffs and no extra weight.
With a fifty-pound limit after back injuries: he used lighter loads.
After two shoulder breaks: he trained lower body and core first, then returned to light upper-body work.
"Rock Cuffs have been particularly invaluable during my recovery from several surgeries. Despite doctor's orders not to lift heavy weights, I have been able to adapt my training." Dave Lucero, retired Chief Warrant Officer
That is the idea today. Light load. Honest work. A way back into fighting shape.
What You Need

RockCuff cuffs for both upper arms and both upper thighs
A sturdy chair
A kitchen counter or sturdy table
A light dumbbell or a water jug
Before you start: review the Before You Start guide for setup, tightness and safety. For placement and dial settings, see Cuff Fitting.
Sets, Reps and Rest
Rep scheme | 30, 15, 15, 15 (first session: 15, 15, 15). Row: 15, 15, 15 per arm (first session: 15, 15 per arm) |
Rest | About 30 seconds between sets, cuffs on |
Moving to the next exercise | About 30 seconds |
Load | Bodyweight, or a light dumbbell or water jug |
Tempo | Lower for 2-3 seconds |
When to stop a set | 2-3 reps before your form changes |
Cuffs | High on both upper arms and both upper thighs, tight the whole session |
Session time | About 22-23 minutes of tightened time, right around the optimal 24 (first session about 15 minutes) |
Put cuffs high on both upper arms and both upper thighs, tighten all four, and keep them tight for the whole session. No cuff change and no mid-session break.
Alternate lower and upper body so one area works while the other recovers:
Sit-to-Stand
Counter Push-Up
Glute Bridge
Supported One-Arm Row
When you finish, loosen all four cuffs.
Right on target: About 24 minutes of tightened time is the optimal length for a BFR session, and this workout lands just under it. If your pace runs a little slower, wrap up around the 24-minute mark, since extra time past that adds little.
Why a light load is enough: RockCuff cuffs restrict venous return, the blood leaving the working muscle, while your arteries stay uninterrupted. That's how a low-intensity activity delivers a high-intensity training stimulus, with no heavy bar required.
Sit-to-Stand

What it is: A chair squat that builds the legs and hips you use to get up, climb and carry.
Sets, reps and load: 30, 15, 15, 15 (first session 15, 15, 15), with about 30 seconds of rest between sets. Bodyweight, or light dumbbells held at your sides. Stop a set 2-3 reps before your form changes.
Cuff placement: All four cuffs on, high on both upper arms and both upper thighs.
How to do it:
Sit tall near the front of a sturdy chair, feet flat and about shoulder-width apart.
Lean slightly forward and stand all the way up without rocking for momentum.
Take 2-3 seconds to sit back down, lightly touching the chair without dropping into it.
Easier: Use a higher seat, or press lightly on the armrests. Harder: Pause for one second just above the seat, or hold light dumbbells.
Coaching cue: Drive through your whole foot and keep your knees tracking over your toes.
Counter Push-Up

What it is: An incline push-up against a kitchen counter or sturdy table that trains the chest, shoulders and triceps.
Sets, reps and load: 30, 15, 15, 15 (first session 15, 15, 15), with about 30 seconds of rest between sets. Bodyweight. Stop a set 2-3 reps before your form changes.
Cuff placement: All four cuffs on, high on both upper arms and both upper thighs.
How to do it:
Put your hands on the edge of the counter a little wider than your shoulders, then walk your feet back until your body forms a straight line.
Take 2-3 seconds to lower your chest toward the edge, keeping your elbows at about 45 degrees from your body.
Press back up to straight arms without locking your elbows hard.
Easier: Do it against a wall, or step your feet closer. Harder: Use a lower surface such as a sturdy chair seat or bench, or add a one-second pause at the bottom.
Coaching cue: Keep your body in one straight line from head to heels, with no sagging hips. Stop short of any shoulder pinch.
Glute Bridge

What it is: A floor hip lift that trains the glutes and hamstrings without loading the spine.
Sets, reps and load: 30, 15, 15, 15 (first session 15, 15, 15), with about 30 seconds of rest between sets. Bodyweight. Stop a set 2-3 reps before your form changes.
Cuff placement: All four cuffs on, high on both upper arms and both upper thighs.
How to do it:
Lie on your back with your knees bent and your feet flat, about hip-width apart.
Press through your heels and lift your hips until your shoulders, hips and knees form a line.
Lower your hips over 2-3 seconds until they lightly touch the floor.
Easier: Lift only partway up. Harder: Hold for two seconds at the top, or rest a light dumbbell across your hips.
Coaching cue: Squeeze your glutes to lift, and don't arch your lower back.
Supported One-Arm Row

What it is: A one-arm dumbbell row, braced on a chair, that trains the upper back and biceps.
Sets, reps and load: 15, 15, 15 per arm, alternating arms each set (first session 15, 15 per arm), with about 30 seconds of rest between sets. Use a light dumbbell, about 25-35% of what you'd normally row. A water jug works too. Stop a set 2-3 reps before your form changes.
Cuff placement: All four cuffs on, high on both upper arms and both upper thighs.
How to do it:
Put one hand on the seat or back of a sturdy chair, step back, and hinge forward with a flat back, letting the weight hang from your other hand. Switch your hand on the chair each time you change arms.
Pull the weight toward your hip, leading with your elbow.
Take 2-3 seconds to lower it until your arm is straight.
Easier: Use no weight, or pull a resistance band anchored low. Harder: Pause for one second at the top, or use a slightly heavier dumbbell.
Note: Switch arms after every set. The working arm's sets are the other arm's rest.
Coaching cue: Pull your shoulder blade back and down before your arm moves, and keep your neck relaxed.
Working Around Old Injuries
If a movement bothers an old injury, swap it or skip it. Keep breathing. Don't hold your breath as you stand up.
BFR Training for Veterans: FAQ
What is a good Veterans Day workout if I'm working around old injuries?
This one is built for it: four light-load, full-body moves (sit-to-stand, counter push-up, glute bridge and supported one-arm row) done with BFR cuffs on both upper arms and both upper thighs, using bodyweight or a light dumbbell. If a movement bothers an old injury, swap it or skip it. Review the Before You Start guide for medical screening, setup and safety before your first session.
How much weight should I use for a BFR workout?
Light. For this session, bodyweight or a light dumbbell is plenty. As a rule, BFR uses about 25-35% of your normal working weight (research typically uses 20-40% of your one-rep max). Stop each set two or three reps before your form changes.
How long should BFR cuffs stay tightened?
About 24 minutes of tightened time is the optimal length for a BFR session. Past that you get diminishing returns, so to keep training, loosen the cuffs for 3-4 minutes and start a new block. The cuffs stay on through the roughly 30-second rests between sets. This full-body session takes about 22-23 minutes of tightened time, right in that range.
Where do the BFR cuffs go for this workout?
High on both upper arms and both upper thighs, tight for the whole session. The Large RockCuff fits thighs from 18 to 34 inches, and each click of the dial changes pressure by 3 mmHg, so you can repeat the same setting every session. See the Cuff Fitting page for placement and settings.
Can I do more than one BFR session a day?
If you do more than one session a day, wait at least 30 minutes between them. Each session sparks a hormone response that peaks after you finish, so give your body time to ride it out and recover before the next one. With BFR, more isn't always better.
Keep learning: BFR FAQs · BFRT Certificate Course · Shop RockCuff cuffs
A Veterans Day Thank-You
To Dave Lucero, and to every veteran and service member reading this: thank you. Your service, and the sacrifices your families carried alongside you, are not lost on us. Whether you're recovering, rebuilding or staying ready, we're honored to be part of the work. Happy Veterans Day from all of us at RockCuff.



Comments